Exercise

Barbell Incline Bench Press - Medium Grip: How to Do It, Muscles Worked

Last updated 26 July 2026

What muscles does the Barbell Incline Bench Press - Medium Grip work?

The Barbell Incline Bench Press - Medium Grip primarily targets the chest, and also recruits the shoulders, triceps as secondary muscles. It's classified as a beginner-level strength movement using barbell.

What are the most common Barbell Incline Bench Press - Medium Grip mistakes?

• Flaring the elbows out to 90 degrees from the torso, which stresses the shoulder joint.
• Bouncing the weight off the chest or letting momentum replace control at the bottom.
• Losing tightness through the upper back and shoulder blades during the press.
• Not locking out fully at the top, cutting the working range of motion short.

How should I program the Barbell Incline Bench Press - Medium Grip — sets, reps and frequency?

As an upper-body pressing movement, it responds well to a moderate-to-heavy 6-10 reps for 3 sets while technique is being built. Most lifters train it once or twice a week as a primary movement in a push/pull/legs or upper/lower split. Add small amounts of weight or an extra rep once every working set can be completed with good form — the same progressive overload principle behind every strength exercise in the library.

What are good Barbell Incline Bench Press - Medium Grip variations and alternatives?

• Barbell Bench Press - Medium Grip — barbell, beginner level, chest
• Decline Barbell Bench Press — barbell, beginner level, chest
• Wide-Grip Barbell Bench Press — barbell, intermediate level, chest
• Decline Dumbbell Bench Press — dumbbell, beginner level, chest

Barbell Incline Bench Press - Medium Grip at a glance

Attribute	Value
Level	Beginner
Equipment	Barbell
Category	Strength
Primary muscles	Chest
Secondary muscles	Shoulders, Triceps

How to do the Barbell Incline Bench Press - Medium Grip, step by step:

1. Step 1. Lie back on an incline bench. Using a medium-width grip (a grip that creates a 90-degree angle in the middle of the movement between the forearms and the upper arms), lift the bar from the rack and hold it straight over you with your arms locked. This will be your starting position.
2. Step 2. As you breathe in, come down slowly until you feel the bar on you upper chest.
3. Step 3. After a second pause, bring the bar back to the starting position as you breathe out and push the bar using your chest muscles. Lock your arms in the contracted position, squeeze your chest, hold for a second and then start coming down slowly again. Tip: it should take at least twice as long to go down than to come up.
4. Step 4. Repeat the movement for the prescribed amount of repetitions.
5. Step 5. When you are done, place the bar back in the rack.